X-Shot Micro 1 Reshell 6 v1.1 - MicroMax

This is a 3D-printable shell from the GenCo Microwerks for the X-Shot Micro 1, a tiny powerhouse of a blaster. All the hardware you need is already provided by the Micro itself. You just need to print parts in the colors of your chosing and you’re good to go to take a screwdriver to it.

The 6th Reshell comes in a 40Max-compatible format, so you can use and reuse it in every blaster that uses 40Max shells. Or just hold it like a flashlight and shoot it that way. This whole thing works best when removing the dart post, so you can use half darts. You will also need to do a small amount of cutting/filing on the catch of the plunger assembly to make this fit into the shell.

---

Printing

All parts can be printed on a bed of 180mm edge length, if just barely. Only the button will need supports. Everything should already be in its proper printing orientation.

The assembly instructions can be found here -> https://wildwestscifi.net/x-shot-micro-reshell-6-micromax-assembly-instructions

---

https://xfoxgames.etsy.com/listing/1641022710/fluxlabs-micromax-xshot-micro-40max <- XFoxGames can make these for you, if you're in the US. Each kit comes with 2 shells here.

https://paperskeletons3d.etsy.com/listing/1665430821 <- PaperSkeleton3D can make these for you in PETG!

---

Changelog
v1.0 - Initial Release.

v1.1
- Merged the rim tube and rim for the shotgun variant and made it two walls thick instead of one. That should make for a better fit, and prevent the tube from sliding on its own.