USB-C Light Box for Card Slinger 3.0

Meant to fit a Card Slinger 3.0, that has been printed in clear/transparent filament. Use with an adhesive led light strip, and either a snap-in USB-c port that provides 5v, or a USB PD trigger board (like this, this, or this) of the appropriate voltage for the strip you use. If you use the linked led strip, you can either wire it to one of the suggestions, or use the already attached USB cable. Just be use to print the version for the snap in port if you go that route, as the light strip will not fit through the opening for the PD trigger board.

This should be printed out of a dark colored opaque plastic, but that's mostly for looks. Can be printed without any supports. If using a PD trigger board, use a strong double-sided tape or glue to attach it to the interior side of the box. the USB-C port should be basically flush with the outside of the box when it is properly installed.

Idea from https://www.printables.com/model/1067700-card-lighter, but re-designed from scratch.