Low Hardware Short Dart Mod Kit -- NERF Recon / Retaliator

Short Dart Mod Kit -- NERF Recon / Retaliator -- Low Hardware

Low hardware short dart mod kit for the NERF Recon / Retaliator 
(just 1 or 2 o-rings and some e-tape needed)

I made this remix for my Recon MK2 and it works really well. 
I think it should also fit the Retaliator.

Installation should be self-explanatory. You'll need to experiment a bit with the appropriate O-rings for the pusher breech to find the one that offers the best balance between seal and priming comfort (the original O-ring from the blaster can also be used for the rear one, but it wasn't tight enough for me, so I replaced it with a different one as well).

After inserting the barrel into the blaster, slide the thin barrel mounting ring from the front all the way back and apply two to three layers of e-tape directly IN FRONT of the ring to prevent the barrel from slipping backward. DO NOT apply the e-tape around the mounting ring, or it may become too wide for a faux barrel.

My other Recon mods free to download in my Printables.

The files are already pre-oriented:

My print settings for PLA:
0,2mm layer height
5 walls
20% gyroid infill
7 top and bottom shell layers
NO supports needed
use a brim if you have poor print bed adhesion!

Thanks to SomeDingus for the files I could use for this remix.