Fireball bottle prison

I made a bottle prison for the 70cl Fireball bottle.
to make it you will need;
1 x “base” part
1 x “top” part
1 x “lid” part
4 x feet (TPU)
6 x M8 threaded rod, each 31cm long, you should get all 6 out of two 1m pieces (stainless looks best)
54 x M8 normal nuts
6 x M8 cap nuts (or 6 more normal, but cap nuts looks better)

Jam two nuts together on the bottom end of all the 6 rods, preferably with some locktite added.
you will need to align the two jamed nuts, as the hole is hexagonal all the way to get better grip on the nuts.
stack all the parts together and add all the nuts.

There is a OBJ file of the compartment in the top, so you can edit and make a holder for some shot glasses or a 13mm spanner or some other gift.

I have also made a base that uses a Bambu Lab LED lamp Kit-001 and lights up the bottle from the underside.
to make this you need:
1 x "Stand with lamp" part
1 x Bambu Lab LED lamp Kit-001
4 x feet (TPU)

Edit: I got my LED-kit delivered and there are some small adjustments needed on the print, these are so small that it is best to adjust the fitment using a knife or file, I made two tabs to hold the LED-unit, these are a bit too big, but easy to cut down on a finished print, and also the opening in the channel for the cable is a bit tight, again just cut a little bit, test if the cable fits, and cut some more if it does not.


I printed this using black BambuLab PLA-CF, this gave the printed parts an amazing surface finish
and for the feet I used some 40D TPU I had.