Adjustable Elevation Riser (0-6,5°)

Doesnt need any hardware to work

I added the steps if you need to adjust the tightness of the rail mounts or if you want to modify it for use with bolts

Assembly:

1.  put the long flat bar with the two holes into the hollow picatinny rail, make sure the side with the 90° edge points upwards. then put one of the 5mm pins through the thickened side of the rail to secure the bar.
2. put a bit of lubrication on the camtrack on the rail and slide the rear mount on (the one with two pins pointing inwards), make sure the tall side is towards the rear
3. put the front mount on and secure it with a 5mm pin
4. position the rails on your blaster and secure them with the two fork pins. to adjust just push one of the mounts around and check the angle on the readout on the left side.