Print In Place Pop-Up Target Bullseye for Catapults and Nerf guns - 100mm/4in 14.8grams

Print, pop-up, aim and fire! 

Target is stepped so that you can do some filament changes to give this target some life!

100mm diameter or about 4 inches.

Filament Swaps

First Layer is .35, rest of the layers printed at .2mm. Starting with red for the center target.

• Pause 1 = .75mm change to orange for second target circle
• Pause 2 = 1.15mm - change red to yellow for third target circle
• Pause 3 = 1.55 - change yellow to green for fourth target circle
• Pause 4 = 1.95 - change black for the rest of the base

My Print Settings:

• Material: PLA
• First layer height: 0.35mm
• Layer height: 0.2mm
• Wall thickness: 0.4mm 
• Wall loops: 2
• Wall order: Outer/Inner
• Wall generator: Classic
• Bottom surface pattern: Rectilinear 
• Top surface pattern: Rectilinear 
• Infill density: ~25% (for a heavier base)
• Infill pattern: adaptive cubic
• Nozzle size: 0.4mm 
• Supports: Nope
• Speed: You decide based on your printer! I printed it kind of slow at 40mm 

Print time is about 1 hour 15 min at the slower speeds