Eaglemoss Star Trek Next Generation magnetic ship stand

Wanted to hang eaglemoss models from the ceiling of a metal cabinet to save shelf space. This should fit the 5" enterprise D or enterprise C models they make. Highly recommend hanging these by sliding them onto the back of the saucer section, as the ships' center of gravity will cause less stress on the clip. For the enterprise D, I recommend printing so the layer lines run the length of the clips, since that direction will be the most load-bearing.

Holes are for 12mm x 2.7mm size magnets.

Recommended to print this with the arrowhead and clips facing up. The back side is flat, with the exception of the middle "crossbar". Use whatever infill settings will give you the highest structural stability, and it might be best to put a small towel or something soft a few inches underneath it until you know your print is holding up reliably. This is the first time I've ever designed a part to hang something off of.

Use the toughest material you have.