Nendoroid/Figma Adapter Mount for IKEA Skadis

Two models are available:

1. Square Adapter Mount (Recommended) - Easier to print and does not require any supports.
2. Circular Adapter Mount - Looks better but requires requires additional supports.

Printing Instructions

Note that depending on your slicer, changing the orientation of the prints can alter the size of the hole slightly. The square mount was created with a 4mm diameter hole while the circular mount was created with a 4.1mm diameter hole to account for the expected print orientation.

If you're having issues with fitting in the nendo/figma stands in to the hole, let me know and I'll see if I can put different versions.

Square Adapter Mount

Just print as is, no supports needed. Print in the same position as in the gcode to get maximum strength for the joint. Printed at 0.2mm layer height with 15% infill. Increase infill if you want more strength.

Circular Adapter Mount

Printed at 0.2mm layer height. I recommend the infill to be set to 100% to increase strength of the joint. Add supports as needed.