Cross Spinner (fidget toy)

This is a cross shaped spinner toy.  I has a latch at the bottom and can spin freely if pressed down.  Or use the latch, it has a good amount of resistance, but can easily break free of it.

Some super glue is required.

Assembly:
First test fitment of all parts.

Then insert the latch with the hole facing out.  Glue the rear button and the pin together, with the pin facing near the closest edge.  Or as seen below.

Then glue the rear button into the hole of the latch. Be careful to only get glue into the latch hole.  Insert the pivot pin into the spinning arm.  If needed use a 1/8 drill bit to smooth out the hole.

With the pivot pin and spinning arm in place, add a tiny amount of glue to the pivot pin.  Then add some glue to pivot cover.  Combine them while being careful to not get any on the rotating arm.  Once dry test for function.  If needed a little bit of oil can be added to the back of the main pivot. It should wear in with a little bit of use and spin easily.