Mini Airsoft / Nerf Targets

Dual Color
Variant 1: Print the target in your base color, and then change the filament to a high-contrast color, such as white or red and print the last .5mm.
Variant 2: Use your slicer to create the dual colored print.

Printing
Infill: 100%
The target should be 100% and the base should also have a high infill to add some weight to it, as to not get knocked down by the wind (if used outdoors).

Assembly
Print the base and the target and then just stick the target into the base. The fit is designed to be tight, but depending on your printing clearance, results may vary and some glue may be needed.

Scaling
You can scale the model up or down, depending on your needs, even though the clearance on the parts then might need some adjustment / post processing.

Safety
Always wear eye protection and only shoot where there are no pets or other people, since BBs will ricochet from the target!