April 23, 2026
Description
I printed the original card holder (which is a great design), but it barely seemed to hold the card in place, so I designed this replacement holder which fits the original stand.
Just print 2 and slide them together. They may need a little sanding, mine have all had little peaks on one end where the nozzle lifted and left a small glob.
I'm using a similar design to make a Magic the Gathering holder.. but it's not ready yet.
Printer:
Da Vinci 1.0
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Notes:
This would probably come out much better at 0.1 layer height, but since I'm just prototyping, I haven't used that setting yet.
License:
Creative Commons — Attribution
brimstone326
