Among Us Travel Chess Set

Made a couple of years ago, this model was printed using filament changes on a Prusa Mini+.  The hats were printed in different colours and glued to the pieces, as was the the pawn “bone” piece.  

Board is modelled from scratch - use the included filament change on early layer to get the different coloured checkerboard.  The entire set was scaled and built to fit into the folding travel sized base which closes with a couple of magnets and uses filament/wire as the hinge material.

Figurines on bases - use the included filament change to get a base of a different colour from your figure, and print two copies of it in your desired crewmate colours.

Bone and guts uses a filament change to get ooey gooey guts over the blood red base.  Very happy with how those turned out.

Hats are quick to print, but i tended to print multiples and pick the “best” ones.  They're prone to detaching because of the tiny contact area with the bed, but since they're such a tiny and quick print you can normally get a few good ones or just run another batch :)

Visors are printed in bulk in a contrasting colour and glued.

Figurine is a modified version (remix) of https://www.printables.com/model/42250-among-us-dead-or-alive-improved, thank you to Shawn for that model.  License follows the CC BY,NC,SA of that model.