Adventure Force Axis Switch Pro Muzzle with lower picatinny rail

Description:
This is a slip-on muzzle for the Adventure Force Axis Switch Pro blaster that includes some lower picatinny for a foregrip. To really make it work, you should shorten the magazine switcher. I have a model out there for that as well that requires no permanent changes. You could also just remove the outer handle from the switcher. The 3mf should include 2 versions. I highly recommend the V2 as the V1 has had issues with the rail screws disconnecting.
https://www.printables.com/model/1700909-adventure-force-axis-switch-pro-magazine-switcher
https://makerworld.com/en/models/2716225-adventure-force-axis-switch-pro-magazine-switcher

Materials:
2x M3x8mm Machine Screws
3x M3x10mm Machine Screws
3x M3 Nuts

Printing Instructions:
You will need supports for the muzzle - but you can turn them off for the picatinny rail. I recommend PETG with 5 walls and 20% gyroid infill, but PLA should be fine.

Installation Instructions:
1. Put the 3 M3 nuts into the grooves inside the barrel. One is at the end of the tunnel.
2. Use the 3 M3x10mm screws to attach the rail to the blaster. The holes will only line up one way. Be sure to engage each of the 3 nuts.
3. Remove the two screws holding the muzzle on the blaster.
4. Slide the new muzzle over the existing orange cage muzzle.
5. Use the 2 M3x8mm screws to attach the new muzzle to the blaster.

Versions:
2026-06-30Initial creation
2026-07-15Tightened screw holes on muzzle side, added 3 nuts to help hold rail, extended rail screws from 8mm to 10mm