Gloomhaven Storage - Harbor Freight trays

This Gloomhaven storage solution uses Harbor Freight "20 Bin Portable Parts Storage Case" https://www.harborfreight.com/19-bin-portable-parts-storage-case-93928.html - item 93928.

Print List

1 Store Divider Stand

3 Store Dividers

6 Monster Standee Trays

1 Boss Standee Tray

1 Monster Stats Tray

2 Event Boxes

4 Event Box Dividers

The "Store" fits in a single large 2x2 tray. Print 3 dividers, as you have four stacks: your current store, your prosperity-gained store cards, designs from chests, and your random items. (A future design may build the side-panel directly into a box, instead of just resting on its side.)

The "Monster Standee Tray" replaces a large tray+two smalls (basically 6 smalls, 3 across by 2 down). You should be able to stack them 3 high. There is enough room for 6 standees per spot, with 6 spots on each tray.

The "Boss Standee Tray" is a similar tray to the Monster Standee Tray (3x2) - it has one extra large spot for the stone golems, and the rest of the space is open for the larger boss standees.

The "Monster Stats Tray" replaces a large tray+two smalls (3x2). The hole in the bottom of the box is to let you push the cards through from the back, for ease of use. There is enough room to stack one of the Monster Standee trays on top.

The "Event Box" replaces a single large 2x2 tray. The hole in the bottom of the box is to let you push cards through from the back, for ease of use. The locked cards go in the bottom, with a separator above it. Cards that were experienced but not trashed, go above that. Another separator goes above those cards, until you shuffle the experienced cards back in. (This occurs when you add a card to that event deck.) Unlocked and non-shuffled cards go on the top layer.

Update: Added "Dead Card Box" for event & random side locations that are removed from game.

Update 3/2/2018: Added "Store_Box_Alternative_to_Stand", where you can print a box with the window built-in...instead of using the Stand inside a default yellow Harbor Freight box. If you print this, you do not need "Store_Divider_Stand".

Print Settings

Printer Brand:

LulzBot

Printer:

Rafts:

Doesn't Matter

Supports:

Notes:

As far as printer bed requirements go, the biggest items are 110mm x 117mm.rnrnEverything except the Store pieces and dividers will need support, as the stands on the bottom of the trays/boxes will raise it up off of the printer bed.rnrnThe Event Box Dividers were printed with PETG, to give it a little big of flex to get inside the Event Box.

Category: Toy & Game Accessories