Travel Catan

This is a complete travel-sized Catan board, except for cards, dice, and build cost cards.

This was designed for printing with an MMU, but most parts can be printed without one. For the parts that currently require MMU (harbor keys and number tokens, trophies and robber) you may be able to load the accents as sub-parts, adjust their position, and then add filament changes in your slicer.

A different box may be required for the non-MMU version, since some pieces may be slightly taller and not fit in the current box.*If you print non-MMU versions, let me know the height of your stacks, and I'll modify the current box.

For multicolor pieces, load the main part and the additional parts, and change the type of the additional parts to "modifier" and select the desired filament. Box lids and robber need to be printed face down. Harbor keys and trophies are best printed face down.

You will need to print:
1 box bottom
1 box top plain (add box top catan outline and fill as modifiers for MMU) (non-mmu see note below)
1 card box
1 card box lid (add card box lid color accents as modifiers for MMU)
6 Standard Board Sections
1 Desert Tile
9 Plain Water Tiles
9 Harbor Tiles
18 Basic Resource Tiles, colored as you choose to represent the 5 resources. 4 Wheat, 4 Wool, 4 Lumber, 3 Brick, 3 Ore
4 harbor key blanks with 3 to 1 harbor key modifier
5 harbor key blanks with 2 to 1 harbor key and resource indicator modifiers
1 set of number tokens (white with red and black modifiers)
1 Trophy blank with Longest Road modifier
1 Trophy blank with Largest Army modifier
1 Robber blank with Robber Accent modifier (non-MMU print robber blank without modifier)

For each of 4 player colors:
5 settlements
4 cities
15 roads (face down)
1 piece box
1 piece box lid (face down)

non-MMU note: Try adding the Box Top Catan Outline as a modifier to the Box Top Plain, and then specify in the settings for the outline: no infill, no perimeters, no bottom layer, and 1 top layer.

There is a customizer "Name Maker" with this thing, for personalizing the box lid. The resultant stl should be properly positioned to use as a modifier for the lid.

Use paper clips or 20 Gauge wire for hinges.

Print instructions

Category: Games Print Settings

Printer Brand: Prusa

Printer: MMU2s

Rafts: No

Supports: No

Resolution: .15

Infill: 5%

Filament: various PLA
Notes:

When printing the box top using MMU, set your wipe tower width to 15 under Print Settings -> Multiple Extruders.