Inline Magazine 16 Shot Hammershot Cylinder.. Oh Yes!

These parts are designed to use a few solid layers on the bottom and then a continuous and unbroken profile all the way up the part. Prusa and Slic3r call this vase mode, while Cura calls it spiralize.

Thanks to Tyrant for pointing this out: For users of Prusa or Slic3r, they don't seem to appreciate the 0.05mm gap separating the lower half of the cylinders on the default 'Slice gap closing radius' setting. This setting is found in 'Print Settings' > 'Advanced' > 'Slice gap closing radius'. If you set this to any value below 0.02mm the model should slice properly.

Make friends and intimidate them with stupid-silly firepower why not? I've seen a few designs here and there for inline clips and I finally put a couple hours into my spiraled cylinder to get half darts stacked and firing.

In brief: the back dart is loose in the cylinder while the front dart is lodged and sealed in the front of the cylinder. When you pull the trigger, air pressurizes around the back dart and uncorks the front dart, leaving the back dart behind. Point the muzzle towards the earth to lodge the back dart in the front, and now it's the front dart.. so pompous and full of itself.

Most of the time, the back dart seats into the front of the cylinder without the help of gravity and you've got 16 rounds without a pause. Currently, the design does require the removal of the Hammershot or Sweet Revenge air restrictor. When the back dart becomes the front dart there's no dart to trigger the restrictor.

For the Hammershot, you may not need a cylinder peg to align the rotor with the blaster, the rotor slips over the little nub on the cylinder arm to align the rotor/cylinder.  For the Sweet Revenge, you can use the cylinder peg from https://www.thingiverse.com/thing:1274005/files.

Printing Instructions

These parts are designed to use a continuous and unbroken profile all the way up the part. Prusa and Slic3r call this vase mode, while Cura calls it spiralize.  Cura wasn't really able to slice more complex spiralized parts from version 4.2 until just recently, so I would recommend either using a release version later than 5.7.

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

NA

Filament color:

Translucent

Filament material:

PETG

Cylinders

Bottom Layers:
4

Line Width:
0.4mm

Wall Speed:
25-30mm/s

Spiralize Outer Contour:
Yup

Rotor

Bottom Layers:
8

Line Width:
0.4mm

Wall Speed:
15mm/s

Spiralize Outer Contour:
Yup