Solenoid Gryphon Foam Dart Blaster

Description

Welcome to the Solenoid Gryphon Blaster Project

This project is a remix of the original Gryphon made by Flygonial https://github.com/Flygonial/The-Gryphon-Foam-Dart-Blaster

Project originally started by Taffy and Ciela in Fusion 360 and further adapted by Egghebrecht in Tinkercad.

This blaster has been tested by multiple people and works perfectly

The blaster uses standard talon magazines and is designed for the FTW Hyperdrive Solenoid

The fileset comes with both a dual stage trigger setup and a 2 trigger setup

Hardware list:

M3 screws 5mm, 8mm, 10mm, 14-16mm for mag release, 20mm for the motor cover
8x6mm M4 Screws to mount the solenoid
8x4-5mm M2 motor screws
4x countersunk m2,6 (standard nerf) screws for the switches (length depending on switch used)
a FTW hyperdrive solenoid
Switches (see wiring schematic)
Connectors (XT 60 or other)
10-20cm of 25mm or other tube for the stock (see original gryphon for imperial options)
Superglue for stock assembly
5mm wide springs for triggers and mag release
4 flywheel motors
Wire suitable for your powerload, heat shrink etc
optional mosfets based on your switch selection

Notes & instructions

Only a dual stage motor cage is available for now, if you add a solenoid you want that 200 fps+ performance don’t you?
In the stl fileset only 40-39,5mm and 40-40mm flywheel cage options are available, the f360 fileset allowes you to specify your own distances parametrically, so if you need other options, head to discord and the f360 fileset
The secondary wire run on the left is purely cosmetic but can be used if needed, you only need to cut a small hole in the motor cover if you want to use it too
For the dual stage trigger it is advised to print both triggers and test which one works best for you, due to differences in switches, print quality, and even screws it the half mm difference between the 2 can make a huge difference
The ‘experimental’ magwell is designed to improve printability, both are available
Front grip: all normal gryphon options are available, both rail and the standard foregrip are included in the fileset
Stock: All gryphon stock options are available, a stock point for a 25mm tube and a 3/4" pvc are included. A 25mm alu tube big stock option is included in the fileset since it is what I needed for my personal build.
Wiring: See the wiring diagram pdf, fitting all the wires in the build can be a bit challenging but is totally possible, just pay attention so the wires don’t hinder the pusher.
It should be possible to thread the pusher onto the solenoid by using a set of pliers to grip both the printed pusher and the solenoid pin.

Category: Toys & Games

License:

Creative Commons — Attribution