Fidget Rocker Switch Clicker

This is clicky rocker switch! Case and Spring parts are compatible with original “Fidget Clicking Wheel 2.0”.

Print Settings:

• Material: PLA, PETG
• Layer height: 0.15 - 0.20mm  (For your information, I tested it at 0.30mm and it was quite tight due to the tolerance.)
• Supports: no
• Perimeters: 2

Assembly: 

Before assembling, fit each wheel into its respective casing and ensure smooth rotation. If the rotation feels stiff, use a file to trim it as necessary.

Finally, set the spring and make sure the wheel is engaged, then attach the opposite side of the case.

Note:

• I recommend that attempting to make a conversion from the original “Fidget Clicking Wheel 2.0” use the hard spring.
• The feel varies greatly depending on the material, try it!

My Other Fidget Toys:
https://www.printables.com/@BaGooN/collections/1156349