Easy Print 1:100 M1A1 Abrams

This is a remix of https://www.thingiverse.com/thing:4718232

Print at 0.12mm layer height with supports on build plate.

Assembly instructions (See images below for reference):

1. Remove support block from under the back of "Turret Top.stl"
2. Superglue "Center Pin.stl" into the hole on the underside of "Turret Top.stl"
3. Superglue "Turret Bottom.stl" onto the bottom of "Turret Top.stl"
4. Insert the finished turret into "Hull Top.stl"
5. Use a soldering iron at low temperature or some superglue to gently fuse "Retention Ring.stl" to the bottom of "Center Pin.stl"Superglue "Hull Bottom.stl" to the bottom of "Hull Top.stl"
6. Align and superglue tracks to the hull.
7. Insert "Cupola.stl" into the turret (Superglue if needed)
8. Superglue "Machine Gun.stl" to the Cupola.

Note: The distance between the custom support and the turret is 0.1mm.