Saturn V - S5 14-S_04 [Split Part]

PART [S5 14-S_04]

from pack 3 of the great Saturn V model from THEAMPHIOXUS: https://cults3d.com/fr/mod%C3%A8le-3d/divers/apollo-15-saturn-5-pack-3-4-etage-s4b

I found very hard to achieve a good quality print due to the steep inward curve printing up to the narrow opening without needing to use support which would cause unsightly damage to the finished model as the only way to place the complete model on the bed was with the wider opening down.

I made a decision to split the model for much easier and cleaner printing and I had to split it in 2 places to achieve this.

I have named them as: S5 14-S_04-[P1] & S5 14-S_04-[P2]

I printed in CURA with the following settings using 0.25mm REVO nozzle:

Initial Layer Height: 0.2mm

Normal Layer Height: 0.1mm

Walls: 2

Bottom: 2

Top: 3

Infill: 15%

Drop on bed as orientated in the model.

a relatively simple task the to use CA glue to join the parts together carefully checking the image of the full model part for orientation of the 2 parts with each other.

Category: Vehicles