Nerf 7 Shot Absolver Shell for 1.25" PVC Fittings

Update: Took forever, but I've finally updated these. After feedback, ID of the "barrels" has been increased to 13mm to try for a better fit. This means the shells can no longer fit inside 1.5" PVC pipe due to the overall increase in size. OD of the shells is 42.2mm compared to 42.418mm for 1.25" fittings. Three different versions:

• 7shot_13mm_shell_insert - This is the barebones "barrels" of the absolver, use this if you want to save print material/time and use 1.25" fittings to make complete shells. Will need hotglue or other space-filling material between the "barrels" and the fitting.
• 7shot_13mm_shell_capped - This has a filled circle on the end to roughly seal inside 1.25" fittings. Use this if you have a 1.25" fitting on your blaster and just want to fit shells that should be a press fit.
• 7shot_13mm_shell_capped&indented - Same as above except there is an indent in the circular end to give more flow to the outer barrels. This is suggested if the exit of your tank is smaller than 1/2" or is butted up against the back of the shell while in use. This one is a little more difficult to print due to the indent.

---

This "shell" is an easier way to have absolver shells ready for you higher powered blasters. It's designed to be a friction fit inside of 1.5" PVC pipe since that is cheaper and easier to come by than 1.25" PVC fittings. I have also added an updated version that should fit 1.25" PVC fittings and has a taller base for a more snug fit. The dart barrels have a barely looser than CPVC fit on darts(.490" vs .485"). I haven't printed this yet to test, so it may need some fiddling with settings.

Category: Toys & Games