Nerf 61 Shot Absolver for 5" ID Pipe/Tube - Updated

Update: New designs with 13mm barrels for better dart fit. These will no longer fit inside 4"fittings and you'll most likely need to find a custom shell solution for them due to the odd sizing. There are four files outlined below:

• 61shot_13mm_shell_insert.stl - The basic design. Just the barrels, the minimum necessary for mounting in a shell.
• 61shot_13mm_shell_insert.step - Same as above but in step format for easy modification.
• 61shot_13mm_shell_capped.stl - Same as the insert but with a 10mm tall 127mm/5" OD section for better centering inside your shell of choice.
• 61shot_13mm_shell_capped.step - Same as above but in step format for easy modification.

---

Are you tired of shooting less than 50 darts at a single time? Do you have a singled drain blaster that your friends are making you change? Then this is probably the absolver for you. If you've got the air power, this absolver will allow you to rain foamy disrespect upon your friends and foes alike. Design to fit inside a 4" PVC fitting with only mild sanding in the corners, this will be a perfect addition to any air-powered loadout.

Please note, this is still a fairly early prototype and needs some testing. As usual, barrel diameter is .490" compared to .485" in CPVC.

Update: I've now included a very experimental print for an adapter to go from this absolver to 2" PVC.

Print Settings

Rafts:

Doesn't Matter

Supports:

Infill:

Minimum of 10%

Category: Toys & Games