Nintendo Switch Lap Stand

Holds your switch upright on uneven/soft surfaces. Great for playing on a bed or lap where the built-in kickstand just falls over.

Works fine with just the print and a naked switch, but if you use Amazon's top case (with the magnetically detachable front cover) and glue some 10x3mm magnets into the print, it sticks there so amazingly well. See the pic of me holding it upside down with the magnets holding it in. And it slides right on/off with one hand very easily.

There's a charger hole in the bottom if you need it. There's also a lip around the front of the platter to set your phone/lighter/keys/whatever. I don't know your life, you use that shelf however you like.

This uses the same docking design as my wall-mounted shelf, check that out too! https://www.thingiverse.com/thing:4729280

No supports needed. A very level bed is a must.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: Solutech PLA White

Category: Toy & Game Accessories