Pentago - Smaller, non-printed beads

Based on https://www.printables.com/model/71762-pentago , I've made it a bit smaller and preferred using premade beads (Perles Rondes Colorées En Acrylique, Sans Trou, Imitation Perlée, Décorative, Diy, Srapbook, Pour Loisirs Créatifs, En Vrac, 3, 4, 8 Ou 10mm - Perles Pour Vêtement - AliExpress), any 10mm beads will do.

I recommend printing the board on textured plate for a cleaner finish.

I've prepared a bambulab specific file, feel free to use it if you own one. It's optimized as much as possible for a clean and fast print on 3 plates : 2 cold and 1 textured. Slow external walls for best results (red would go from orange to a darker red depending on the speed, while this is not an issue this was not something I was looking for).

I've used some screws that were laying there, not countersunk and it still works, otherwise use the recommended M3x10 countersunk screws.

Printed in orange and red, using black and white beads.

Beads holes are not too shallow so beads can be picked up easily.

Please refer to Ziyay | Printables.com model for informations, rules and all you need to assemble etc…