Fully Printable Parachute for Toy Soldier

Fully printable parachute for toy soldier. Vase mode for lower weight. No glue needed. The model consists of three parts, which is printed separately. I printed it on MINI+ with 0,4mm nozzle and PLA.

Print info

Main body needs to be printed in VASE mode with just one bottom layer (because of weight).

Rope needs to be printed with 100% infill (4x).

Backpack can be printed with default configuration.

• Material: PLA

• Nozzle: 0,4mm

• Layer: 0,2mm

• Supports: NO

• Print time: 2h 8m

• Weight: 17g

Assembly

One end of the rope needs to be pushed inside hole on backpack and other end to parachute. Maybe it can be little difficult to push rope inside a backpack, because of lower tolerance. In this case you should use pliers to push it inside carefully, but then it will hold up inside well. On the parachute is higher tolerance of hole, so there is no problem to push it in. In case of crash it will disconnect instead of breaking it.

To achieve a successful drop, let it go from higher height.

Thank you for downloading and like.