Better Propellers for Drill and Pull Launcher

Overview

This is an addition to this model: https://www.printables.com/model/412370-new-and-improved-pull-or-drill-powered-propeller-l

These propellers work with the original remixed model and offer superior lift and a slower fall.  The profile is not as aggressive as drones but does twist from a slow angle of attack to a more aggressive one.  This aggressive angle of attack is what will require support due to the angles being less than 45 degrees.  If you have an ethical or moral dilemma using any supports, consider recycling the supports and failed prints using a service such as Printerior.  Avoidance is better than recycling but not always possible.

Print Settings

• Material: PETG (PLA will work but will be more fragile)
• Infill: 10%
• Walls: 2
• Nozzle: 0.6mm (0.4 will work but there may be more supports)
• Supports: Yes

Changelog

3/12/3023 - Increased all angles inside the center dome from 45 to 48 degrees to reduce likelihood of supports being placed inside the center using a 0.4mm nozzle