Tablet/Phone Stand for Wyrmwood MGT (Modular Gaming Table)

This stand can be used inside or outside the table, but is designed for the outside.  If you are looking for specific sizes/orientations, the tablet_stand.scad file should be able to generate anything you need using OpenSCAD.  I can generate a model for you if needed, just let me know what you want to see.

You will need the following hardware to use this print with your table:

• #6x0.5" wood screw (stainless steel recommended) - https://a.co/d/heZ6jlC
• 12mm diameter, 5mm deep countersunk magnet (any polarity) - https://jc-magnetics.com/Magnet-N52-12mm-5mm-Hole-4mm-Countersunk-Ring?search=JCN52-CK12-5-H4

I am mixing imperial and metric hardware here.  M3 was just a little thin for the 4mm bore in the magnet, M4 screws were too tight to fit through.  #6 screws are around 3.5mm so they fit perfectly.

UPDATE 2023-04-13: The rounded edges made this a little too easy to remove by pulling straight down.  The new design has slightly less rounded corners and can support considerably more weight.