Big Top game insert

This is an insert designed to organize the game pieces for the game Big Top, published by AllPlay. It mainly consists of a number of boxes with lids, one for each player, one for the bank, and one for the other tokens. (The lids also securely fit the bottom of the boxes for storage during game play!) It also has a holder for the cards in the game. I did design the card holder to be a bit larger than the cards so that you might be able to sleeve the cards and still use it, but the cards are an odd size and I don't have any sleeves that fit the cards so I haven't tested this.

NOTE: The boxes print best at 0.16 line height (0.4 nozzle) but 0.20 or thicker is fine for everything else. You really want to use 0.16 (or lower) for the boxes with lids as there are some small but steep overhangs that are supported much better by a slightly smaller line height. (Check your slice preview.) No supports should be needed if you print at 0.16 or lower.

I printed these with 15% gyroid infill, but you can use 10% infill if you increase the number of top shell layers by one (or if you don't care about slight imperfections in the bottoms of the boxes). PLA/PLA+ works great for all of these.

Print one of every model except the player boxes, of whcih you'll need four, in the player colors.

Last, but not least! The lids for all the boxes are friction fit and can be stored on the bottom of their boxes so they don't get lost during play. The tolerances on these can be somewhat tight, but they came out beautifully on my Bambu X1C.