Carrera track safety zone / Sicherheitszone mit Bande 1:32

This is a complete set of safety zone parts with barrier, attachable to the Carrera tracks with these red connectors (check my other designs if you want to print some of these: https://www.prusaprinters.org/de/prints/50970-carrera-track-connector).

Features:

Every part can be printed in one piece (include color/filament changes as you like) or print bottom, middle and top separately and glue it together afterwards
Every part has the same spacing for the connectors as the original tracks, so just connect them with the red connectors to the tracks and/or next safety zone piece
Bridging legs can be added to support safety barrier for track parts which do not lie on the ground.
Safety barrier is far enough from the tracks to support proper drift action (yay!)
No supports needed! The bridges of the bottom part are short enough to print in the air and bridge them.
For every carrera track piece (as far as I've found out) there is a corresponding inner/outer safety barrier, including start/end pieces.
To find out what you need check for specifications in the internet (or, e.g. http://www.slotcars4you.de/shop/images/products/ue_schienen.jpg)

Some of the track turns were bigger than my print volume, so I divided the safety zone by half. So for some turns you have to print two pieces for one track piece.

If something doesn't fit properly or you're missing something, please let me know! Since these are a lot of parts I may have missed something (for sure). Please let me know when something's missing.

If you print it post a make!

If you like it tip me!