August 23, 2023
Description
Following this tutorial again, here is another dragon, this time an aquatic dragon.
And with help from the sculpting tools and modifiers blender has to offer, the dragon was formed.
Should you wish to design and create your own dragon, this tutorial is must-see; it goes into so much detail and every point in the design process is very well described!
The tutorial was followed using Blender v2.93.
The final model was printed in PETG and using 0.15 mm layer height. No supports were used for this print.
After printing, some of the joints may need a bit of help to be loosened but after that, they should work just fine. Some joints may be weaker than others so try not to cause too much tension on them.
If you want, you can check out these other dragons:
https://www.printables.com/model/372371-articulated-crystal-dragon
https://www.printables.com/model/365346-articulated-fire-dragon
Remakes in PLA or other material would be very much appreciated.
License:
Creative Commons — Attribution — Noncommercial
daGill
