September 2, 2023
Description
This model was created in Blender v2.93. and designed to look like a dragon with a mechanical/ steampunk theme.
With help from the sculpting tools and blender's modifiers, the dragon was finally created!
The final model was printed in PETG and using 0.15 mm layer height. No supports were used for this print.
After printing, some of the joints may need a bit of help to be loosened but after that, they should work just fine. Some joints may be weaker than others so try not to cause too much tension on them.
If you want, you can check out these other dragons:
https://www.printables.com/model/561147-articulated-aquatic-dragon
https://www.printables.com/model/372371-articulated-crystal-dragon
https://www.printables.com/model/365346-articulated-fire-dragon
Remakes in PLA or other material would be very much appreciated.
License:
Creative Commons — Attribution — Noncommercial
daGill
