The PERFECT Gloomhaven/Frosthaven standee- with optional magnets

This is the PERFECT Gloomhaven / Frosthaven / Jaws of the Lion standee!

You can print this and rush to show it off to your wife, which will undoubtedly raise an eyebrow at your excitement, in complete disbelief at how great your next session of  Gloomhaven will be. That game where she loses sight of you for a couple of hours while you play with your friends!

The PERFECT standee has those exciting features:

• Monsters and conditions support with an angle insert to avoid damaging the cardboard token
• HP wheel with extruded numbers face up for easier multi color printing.
• Clamp hole to hold base together when manipulating. The top won’t come off by accident
• CLICK grips to prevent HP from accidentally moving by themselves when manipulating the base
• Grip on HP wheel for easier selection of HP
• Dented gear for HP Click Grip. Each HP selection does a nice CLICK
• +10 HP plate with engraved text face up for easier color printing.
• Dented gear on 10 HP plate. Gives a nice additional hold for turning the HP wheel

2021-08 update: Added +10HP plate with stars for better grip. We stack those plates at the bottom of the standee when the miniature has more than 10HP.

2022-04 update: Rounded the top of the click grip for easier fitting (suggested by Tonybruce in the comments)

2023-07 update: Made the top condition marker holder stronger/Thicker. Added .3mf files for +10HP magnet plates instead of the tight fit. I didn't test yet, but it should fit the 5mm X 1mm magnets available on aliexpress or amazon. You probably do not need to reprint the Shaft plate if you already printed it with the standard 2mm hole under. But i made a new shaft plate with a 1.2mm hole to better fit the 1mm X 5mm magnets just in case.

2024-06 New make and test with PETG at 0.15mm worked very well on my MK4. Printed 30+ of them for frosthaven.

2024-07 Created a new model to hold the monster stats card and the monster deck. Since we do not need to put the HP tokens on the monster card anymore, we can now use a rack to hold the monster stats card and the combat deck, here: https://www.printables.com/model/934554-gloomhaven-frosthaven-stackable-monster-deck-holde

Print instructions:

• Tested print at 0.1mm and 0.15mm with PLA or PETG, no support.
• For color printing of the +10hp base, add one or two layers of color at the bottom layer of the engraving. There will be a small colored line around the 10hp base barely visible.
• For color printing of the CLICK wheel numbers, use the standard top layer color change since the numbers are extruded.
• The print is a tight 0.1mm fit, for some it works nicely and others might need to use a little sandpaper to help the fit. My tests at 0.15mm on the mK4 also worked very well.