February 15, 2024
Description
Do not expect to see this model working on a shipwreck or collecting material from an impact site or minig on an asteroid field.
This is the model that a large corporare want as a security service.
It is unlikely that the robot is owned by the pilot due to the elevate cost of purchase and maintenance.
Design:
No support, no overhangs, no bridges, no climbing over 45°.
No glue and no screws are needed, you already have everything tou need.
My model has to be printable, assemblable an playable with a setup far from optimal.
The model has 13 point of articulation, every joint is designed to have some amount of elasticity and to be printed and put together even if the printer used is not the most precise.
There are 4 files: one for each color, the parts are oriented in a way that does not require supports.
The armor can be hold in place by some 1.75mm filament.
The assembly of the robot is quite straightforward and if you end up with an alternative model...well, post it! :)
Almost every part of this robot is interchangable with my other 0-waste models.
Notes:
I tested this model on a full stock (and warped bed) Ender3pro with cheap, wet PLA+ filament. I am quite confident that your print will result better than mine.
I suggest 0.1mm on layer height and at least 1mm on wall/top/bottom thickness.
Post-Printing:
I hate the post-print process as much as I hate to need something non 3d-printable to assemble my project...
...so I designed this figure to be ready to be assembled just out of the printing bed.
License:
Creative Commons — Attribution
70r71
