Hextraction Game Stable Foot for Leg

For Christmas this year, I printed out the basic set of Hextraction ( http://playhextraction.com ).  I printed what I thought was the “basic” set up (although that is not very clear) which included some truss-looking support legs to tilt the game board.  These support legs are hella-unstable … like, you can play, but a slight push too hard and the whole thing topples over ruining the game.

I figured if I could force the support legs to not tip, there would be joy.

I did iterate a little to get the tolerances right … well … functional anyway (I am not a GDT guy)

Here is my support leg - happy happy, joy joy!  It works

I printed this on my Anycubic Vyper at 0.3 layer height, PLA, 195 C, at about 60 mm/sec. and it took just about an hour per foot.