DUMMY 13 goes to COMIC CON - Tyrael V2.0

• Slide pieces of filament (same as the jewelry of the sword) into the scarf mounts and glue them from inside
• Put on the scarf
• Slide it into the armor
• Cut off the filament pieces inside the armor and use glue if necessary
• Sand the outer ends of the filament pieces
• Use a hairdryer or lighter to heat the scarf slightly and give the scarf a realistic look

• Stick and, if necessary, glue the wings onto the spikes and put them onto the armor
• Use a hairdryer to bend the wings (see pictures)

• Attach the sword blade to the handle and fix it with glue
• Press in the inlay

Slide the head into the hood and press it in with gentle force on the chin.

If this is not possible, it is probably due to the following points:

•  Check the inside of the hood to see if it has been printed cleanly and remove any filament debris that is sticking out
• Has the brim been removed cleanly?
• The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife