Car Truck Air Vent Prototype

Car/Truck Air Vent Prototype for your needs.

 I Printed with PETG for flexibility 

Supports: Yes, Just the Vent

Dimensions:

Resolution: 0.2 mm

Infill:  15%-20%

Brim:  Yes, Vent/Frame

STEP 1: Put the Flaps into the holes Make sure the flap with the notch goes in the middle.⬇

STEP 2: Push down the circles at the end of the pegs to cap it off⬇

STEP 3: Slowly Push/wiggle in the whole flap set up into the vent and line up the pegs on both sides. Don’t rush and be careful while pushing it in.⬇

STEP 4: Slow and carefully Push the vent into the frame and watch the side pegs.⬇

thanks for printing!