Dig your way out insert organizer vertical and sleeves compatible

I designed this insert because I could not close the box with sleeved cards.

It comes with a few "enhancements" compared to the vanilla box:

• Gang cards holders, in order to make it more readable across the table
• Cards holders that can be put on the board directly
• Compatible with sleeved cards
• Compatible for vertical storage

Here is what to print and how to store:

/!\ DYWO-org is not made to be print, just to display all of the pieces

First floor

Cards holder [x4]

4 "half sized" cards holders that fit in the bottom / corner of the box.

• One for the gang's cards
• One for the past / Michel[le] cards
• One for the knives
• One for the spoon / pickaxe / shovel

Cards holder full height [x2]

2 "full sized" cards holders that fit in the same direction as previous cards holders just besides. They are make to hold the "search" cards. One can be used to hold discarded cards

Cells [x1]

Made to look like a prison and hold part of the prisonners. To be stored besides the cards holders.

Cells short [x1]

Made to look like a prison and hold part of the prisonners and the gang holders. To be stored besides the cards holders.

Second floor

Player boards [noprint]

I designed an holder for the player board but it's pretty useless because they hold themselves pretty tight anyway.

You can put the player boards directly on top of the 4 small cards holders, in the corner.

Dice - cigs - tokens [x1]

This will fit below the player bords, on top of the small cards holders.

It it made to hold the tokens and the dice.

Fitting all the cigarettes can be challenging, one will need to put the "5 cigs" tokens first and then the other ones on top.

I may designed a top part in the future if it becomes messy.

filler [x1]

This is a small part to fit besides the player boards and avoid space and movement.

There is nothing to specifically fit in this part but you can put extra cigs.

Extra

Gang holders [x6/x2]

I designed this because with sleeved cards and light reflection I could not see well cards across the table.

One piece is made to hold all of one gang's cards.

There is a plane part that goes underneath the board in order to avoid tipping over.

It comes in 2 flavor :

• One by one -> Print Cartel / Crew / Bikers / Bratva / Queers / Triad once each (you can use different colors :) )
• Three by Three -> Print Bikers-cartel-crew and Queers-triad-bratva once each

I designed small holes for 3mm(diam)x1mm(depth) magnets.

This is if you want them to "stuck" together.

Theses can be stored in the cells, in you print the One by One version, all 6 of them can be stored on top of each others.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: GST3D PLA+ Orange and Grey mostly

Notes:

Category: Toy & Game Accessories