This is a new slider for Dracula's Tower Puzzle Box that has the magnet insertion at the rear to provide a flat gliding surface across the base.
You can see both versions in the picture.
Printing instructions
- Print the .stl file as-oriented.
- A brim might help.
Installation instructions
- Check the magnet orientation first!
- Push the magnets in from the rear of the slide into the two openings.
- It should be a tight squeeze, but you can optionally add a drop of glue in the opening end to keep it from moving.
Other notes
- If you haven't glued the magnets in yet, you can use a small pry tool from the screw hole to push them out.
Thank you to 3D Printy for an amazing model!
Adam
