Matrixfire Lower Picatinny

Have you ever had the need to add an attachment on the bottom of your Matrixfire? If so this is the solution!

Based on the Masterkey addon designed by Spyder, this kit uses the same anchoring points in order to add a picatinny rail instead of attaching a whole Magnus.

Printing Instructions

The Left and Right mounts need to be printed with the outer faces on the printbed, the rear with its lower face on the printbed and supports only from the buildplate, the rest can be printed flat, but remember to print 4 nut plates.

Hardware

10 m3 nuts, 3 20mmx3m hex bolts, 7 8mmx3m hex bolts,

Assembly instructions

First hammer in the rear mount three nuts in its hexagonal holes, screw in a bolt to help you. Next hammer another three nuts in the right mount and the last four in the nut plates. To assemble it all first slide the rear mount on the Matrixfire, then one of the lateral mounts, insert the nut plates in the apposite holes (be careful to point the nuts towards the blaster), then slide on the other lateral mount and screw it all with the 20mm bolts. To finish off use the 8mm bolts to screw on the rails.