Propellor with leds for "Strong Flying Propeller / Pull Copter (No Supports)"

I took the original propeller and added LED's because LED's make anything better. especially when it get's dark!

I'll be honest this does add some weight to the propeller so flight times get a lot shorter… but anything for LED"s right?

i used those fast flashing RGB LED's

https://nl.aliexpress.com/item/1005003320164853.html 

^^ all of these led's are flashy and should work ^^ 

Just cut the LED's pins to about 1cm place the pin with the flat side on the led on the lower hole and place it in. Bend the upper pins up and place a standard CR2032 in the middle with + side up(as in pictures).

To remove the battery you can use a screwdriver or something pointy to push it out from the bottom up.

i did model a small cap to, but i had some trouble properly sticking it in. maybe in the future i will make a V2.