Guiro - the whole Percussion frog with support only in the mouth

Percussion Frog 90% infill, WITH SUPPORT, only in the mouth

In Prusa Slicer, you can now easily add support manually with the brush. But it's still not that easy. So here are my .3mf-files (for the MK4).

Two versions: Original size and 200 % size.

I recommend printing the 200 % frog (with 90Proz infill) with PLA. It is realy loud and sounds very good :-).

Tip: To remove the support, simply "press down hard on the teeth" with pliers or a fine knife, at the top and again at the bottom if necessary - on both sides of the mouth - then the support will pop out in one piece :-). Take courage :-).