As usual the model part consist a big parts but the very small also so pay attention to the description and attached pictures. As usual be extremely careful during the assembly itself and work slowly and cautiously. If you manage to damage or break some part despite being extra careful you should "weld" it with a soldering gun rather than gluing it with super glue.
For today I prepared to you all connection rods for connection of the sidecar frame to the motorcycle.
If you will need more pictures for better understanding, you can see here:
backrest_1 - 1 piece, brown PLA, 10% infill, 0.15-0.2 layer.
backrest_2 - 1 piece, red PLA, 50% infill, 0.15-0.2 layer.
seat_1 - 1 piece, brown PLA, 10% infill, 0.15-0.2 layer.
seat_2 - 1 piece, red PLA, 50% infill, 0.15-0.2 layer.
Assembly instruction:
Glue the backrest_2 into the correct place in the backrest_1.
Glue the seat_2 into the correct place in the seat_1.
Glue a piece of the red filament into the groove around the seat and the backrest assembly. In the corners use lighter for heating of the filament to prevent fiber breakage. The fiber of the filament fix by superglue
Screw seat_holder on the seat assembly by 4 pcs of M1.2-5 screw.
Screw backrest_holder on the backrest assembly by 4 pcs of M1.2-5 screw.
at second we can complete the padding of the sidecar body
Printing instruction:
left_padding - 1 piece, brown PLA, 100% infill, 0.15-0.2 layer.
right_padding - 1 piece, brown PLA, 100% infill, 0.15-0.2 layer.
pocket - 1 piece, red PLA, 100% infill, 0.15-0.2 layer.
Assembly instruction:
Glue the pocket into the correct place in the left_padding.
Glue the seat_2 into the correct place in the seat_1.
Insert the left padding into the sidecar body and screw it by screws that holds the decorative moldings from outside.
Install the right padding in the same way as the left one.
Insert saddle assembly and make sure and make sure the saddle is hooked by the holder into the yoke located on the floor.
Insert the backrest on its place.
And.. that's all for now :)
Bill of material:
8x screw M1.2-5 mm
superglue
I hope you had fun during building and everything went smoothly.
You can look forward to the next part. The 6th part is under progress right now ;)
jawarmaniak
