July 9, 2024
Description
This 6 nimmt! Card Box with multicoloured logo is based on the UNO Card Box by Markus_p.
I have included the bottom, inner card holder, and latch in case the original changes them, but they are as of the time of this upload unchanged from the original (except I re-oriented the bottom case in the orientation it's recommended to be printed in).
I printed 4 layers of the logo using my MMU, because I had at least one filament that needed a few layers to look good, but I included a 1-layer version if you're changing filaments by hand.
The inner card holder can be glued in place. Note that the beveled side should be at the front. The box will not close properly if the card holder is glued the other way around. Test before gluing.
For the hinges you will need 6x additional M3x30mm screws.
Filament used:
License:
Creative Commons — Attribution — Noncommercial — Share Alike
koil
