December 17, 2021
Description
After 12 years, the water tank cap shattered. I redid it and printed it in PLA, it should hold even if the temperature in the engine compartment is a bit high (but not very high); I think it will soften a bit but it should be fine. If any problems come up I will report it!
Good print!
If you found it useful, and if you like, you can offer me a coffee!, it will be an extra motivation to continue designing.
Resolution:
200
Infill:
60
Notes:
Print it with a support of 5 mm at the base and inclined at 30 °
License:
Creative Commons — Attribution
ThorLAB
