February 12, 2016
Description
Update 14.01.2017
If you are using softer materials are not powerful enough for quick release and ability to pop up.
I uploaded a 0.5mm and 1mm increased a hingedistance version. This results in a stronger locking, but it increases the possibility of breaking clamp.
The correct size may be selected experimentally. I PLA and PET-G is the event of the basic size work.
It results in failure of the locking even if the actual clamp inside diameter is smaller than the captured light. This problem is more scaling should be improved.
Update 25.02.2016
I reinforced the hook.
After printing more difficult to disassemble, but let the violence.
Update 16.02.2016
I've fixed the vulnerability of connector base.
Operation is tested. Everything works perfectly.
I bored with the lack of a normal quality of light, the normal price.
So I took a cheap but good Chinese LED lamp and was planning to add a powerful and convenient mounting bracket.
Both clamps, approx. 25.4mm ( 1inch) diameter planning.
Material: PLA
Nozzle: 0.4 mm
Layer: 0,2mm
Speed: 30-50mm / s
Wall thickness: 1.2 mm
Cooling is highly recommended.
Support is recommended.
Hinges requires first breaking strength, but it can tolerate without any problem.
Hooks should be separated carefully, this is the weak point.
An M3 * 8mm nut and bolt and a nut and bolt M3 * 12-16mm need to be assembled.
License:
Creative Commons - Attribution
KeriL
