Yet Another Spool Stand and Spacer

Nothing fancy to this Spool stand.

It uses a 1/2 inch PVC pipe for its support bar. I put wire ties on the ends to keep it from moving Axially. Thought maybe to make end caps at some point. If that gets done, they will be added to this design.

Let's see, what else? Oh, due to adding a couple of pull-outs and push-ins it should be a bit stronger than a smooth print. Put a bit of super glue between the spacer and the 2 stand. The pins work well also, but with a lot of vibration, the glue seems to be required. Place a couple of pieces of double sided tape under the stands (or screw it down) and that's about all you need.

The print is strong enough that it does not bend, flex, or vibrate any. I have tried several others and all of them seemed to have their issues. While I have not tried all of them, this one seems to be doing just fine.

I hope that you might agree.

Bill.

PS. I have not tried it yet, but it is probably strong enough to hang from a wall or under a shelf.