1/10th Scale R/C Wheels for 12mm hex, 4 different models

These wheels are designed for a 12mm hex drive system and vary in offsets and diameters. 52mm wheels are more common in drifting r/c cars while 62mm wheels are more common in track r/c cars. Depending on the filament material used, these wheels can outperform the common injection molded r/c car wheels sold worldwide today.

NOTES:
-The ribbed wheels are designed to print in one orientation only, please view the specs for each wheel down below. The ribs one of the lips have a chamfer of 55 degrees on one side while flat on the other. You should set your settings so that the support material only supports the hub and spokes but not the outter ribs by adjusting the support threshhold angle.

-The center hole is just a pilot hole and should be drilled out. a suggested drill bit size is 3/32", but you may try something else.

WA6 25 26 DF1
-Diameter: 52mm
-Width: 25mm
-Offset: -6mm
-Print: Hex socket facing down
-Support Material: yes, 35 degree threshold (Slic3r)

WA10 38 31 LA9 V2.2
-Diameter: 62.0mm
-Width: 37.5mm
-Offset: -10mm
-Print: Hex socket facing up
-Support Material: no

WA4 38 31 LA9 V2.1
-Diameter: 62.0mm
-Width: 37.5mm
-Offset: -4mm
-Print: Hex socket facing up
-Support Material: no

WA6 25 26 MS2
-Diameter: 52.0mm
-Width: 25mm
-Offset: -6mm
-Print: Hex socket facing down
-Support Material: yes, 35 degree threshold (Slic3r)

WA6_25_26_DF2
-Diameter: 52mm
-Width: 25mm
-Offset: -6mm
-Print: Hex socket facing down
-Support Material: yes, 35 degree threshold (Slic3r)

Please submit your comments and questions. Let me know what you think