Hairspray Pump

*Please read the safety concern section below* Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools. I'm not a fan of removing my glass bed every time I re-apply hairspray so I usually fold a paper towel into a little square, and spray the hairspray onto there, and then wipe it on in a thin layer in the middle of the bed. This has worked great, except I need two hands to do this, and I always end up coating the other hand in hairspray. I was modeled after a can of unscented extra super hold Aquanet, but this has fit with a wide range of compression cans. *********NOTE********* *********If It doesn't mist out and it ends up streaming out, (the hole may seal due to over extrusion), just take a thin needle or pin and tap it into the hole. I used a 0.5mm needle to enlarge my hole, mists perfectly now********* 1) Print this out 2) Pull off the spray nozzle on your bottle of hairspray 3) Snap this into place 4) ... 5) You're done! Now, I have a little sheet of paper towel folded next to the can, and every time I want to apply some hairspray to the bed single handedly, I just take the paper towel, and press down on the mouth quickly, and wipe that on the bed. Nice single even coating of hairspray!