Ghost Body Front w/ Magnets - Original 6 Petal LED Tea Light

Work in progress attempt at adding dieselkings magnet holes to the standard large ghost front body by BoldPrintShop. Holes appear to line up with the rear. Unsure about magnet hole depth. Feedback is appreciated as my printer is down at the moment. I can tweak as needed. Adjustment measurements in mm's is preferred. I only edited out the pin holes from BoldPrintShop original large front STL and inserted the magnet holes based on dieselking's sizing and position so it should be dimensionally the same as the originals.

Follow print settings suggested in other files. I personally have printed these in .15 and .20 mm layer heights but they look the same really. 20-30% infill but your preferences may vary.

Update 5/4/17: So finally got around to printing them and it looks like I pretty much nailed the positioning. So I am going to go ahead and set this as final. If anything the tolerances of your printer may make the hole a layer too shallow. I was able to fix this with a dremel carving bit. You may or may not have this issue. Please still leave a comment if you have any problems and I can try and tweak it for you.