Customizable Skateboard wall hangar

[Edit again: Added an option hook on left or right side to hold a charging cable or jacket]
[Edit: Added double and leaning ribs for even more strength]
Make a hangar for your board that fits your board, printer and wall.

1. Choose "Wheel diameter" and "Upright height" as principle measurements. Ensure Smooth is off. Upright height must fit on your printer bed.
2. Adjust the support, rib, and plate thicknesses.
3. Adjust Lip angle, which determines how much of a grip your hangar has on the board.
4. Visualise the setup of both hangars with your truck dimensions in the Draw section.
5. Tweak the Rib angle if you want a smooth transition at the bottom of the Upright.
6. Finally turn on Smooth. This may take a while to calculate. Up to 5 mins so be patient and turn it off if you want to make more adjustments.

Customize it until you get what you need.

• Will print on small or large beds.
• Does not need support.
• Wheel sizes from 40-100mm in diameter.

Suggest you use a hex infill for strength, especially if you want the thinner support sections and rib.
[Edit: - added an image showing strain guage at 12 kilos. but hang tested it at 15kilos(33lbs) for a single. so 30kg or 66lbs for two hangars. Pretty much OK for your average board, raincoats, and extra batteries :)) ]

I've been meaning to make this for a while but this video pushed me into actually doing it. Thanks #skateforce.
https://www.youtube.com/watch?v=pVH-GfD4Sfo

P.S. don't forget my Skate truck risers and drill template.

• https://www.thingiverse.com/thing:1731039
• https://www.thingiverse.com/thing:1726796